RobareenoApr 191 minBuild Plate Size for the Spray Jetboat.This was a user question so I thought I'd throw this image up here. The below picture represents the largest piece of the boat to print. ...
RobareenoJan 21, 20211 minThe Spray Jetboat. Creating the CockpitThis is the fully assembled cockpit with the sealing ring below. The The STL files do not have the material texture as shown. Rendering...
RobareenoJan 21, 20211 minTesting the Jet Spray Hull no1 at White Rock Lake in Dallas.We had a successful test run of The Spray 3D printed RC jetboat on the docks of the White Rock Boat Club. All runs of this sort lead to...
RobareenoAug 13, 20201 min3-D print instructions for the Spray Jet boat rear turbine body.This is a video on how to set up the rear Jet boat main turbine body up to successfully print this working part.
RobareenoAug 13, 20203 minCura Slicer settings for the Spray JetboatOur recommendations for Cura Slicer settings for the Spray Jetboat.
RobareenoAug 13, 20201 min3D print instructions for the Jet Thruster Main BodyThe image below is of the Main jet body in a translucent red color for clarity along with support material appearing in clear. This was...
